13 / EN
Washing Machine / User’s Manual
4.4.3 Removing transportation safety bolts
1 Loose all transportation safety bolts with an appropriate wrench until they turn freely
(C)
.
2 Remove the transport safety bolts by turning them slightly.
3 Insert the plastic covers in the bag containing the user manual to the openings on the
rear panel.
(P)
A
CAUTION:
Remove the transportation safety bolts before operating the product! Otherwise, the
product will be damaged.
C
Keep the transportation safety bolts in a safe place to reuse when the product needs to be moved
again in the future.
Install the transport safety bolts in reverse order of the disassembly procedure.
Never move the product without the transportation safety bolts properly fixed in place!
4.4.4 Connecting water supply
C
The water supply pressure required to run the product is between 1 to 10 bars (0.1 – 10 MPa). It is
necessary to have 10 – 80 liters of water flowing from the fully open tap in 1 minute to have your
product run smoothly. Attach a pressure reducing valve if water pressure is higher.
If you are going to use the double water-inlet product as a single (cold) water-inlet unit, you must
install the supplied stopper to the hot water valve before operating the product. (Applies for the
products supplied together with a blind stopper group.)
A
CAUTION:
Models with a single water inlet should not be connected to the hot water tap. In such a
case the laundry will get damaged or the product will switch to protection mode and will not operate.
CAUTION:
Do not use old or used water inlet hoses on the new product. It may cause stains on
your laundry.
Connect the special water supply hoses supplied with the product to the
water inlets on the product. Red hose (left) (max. 90 ºC) is for hot water
inlet, blue hose (right) (max. 25 ºC) is for cold water inlet.
Make sure that the hot and cold water taps are connected correctly when
the product is being installed. If connected incorrectly, your laundry will
come out hot at the end of the washing process and wear out.
1 Tighten the nuts of the hose by hand. Never use a tool when tightening the nuts.
2 When hose connection is completed, check whether there is leak problems at the
connection points by opening the taps fully. If any leaks occur, turn off the tap and
remove the nut. Retighten the nut carefully after checking the seal. In order to prevent
the water leaks and resultant damages, keep the taps closed when you do not use
the product.
Содержание 8143 CMK
Страница 1: ...8143 CMK 2820523995_EN 17 04 14 15 40 Washing Machine User s Manual Document Number ...
Страница 47: ...47 EN Washing Machine User s Manual ...
Страница 52: ...www beko com ...