Product Specifications
Beijer Electronics, MAEN945B
11
3.3 Mounting Procedure
1. Cut out the control front panel to match the dimensions (mm) specified in
section
3.2 External and Cut-out Dimensions
2. Mount the operator terminal into the cut-out. Insert the fixtures to the
holes on the unit and fasten the screws into the front panel. Do not tighten
the screws with too much or uneven force, or it may cause the deformation
of the operator terminal.
3. The operator terminal is to be installed within the angle of 0 to 135
°
as
shown below.
3.4 Grounding
To make sure that the operator terminal works properly and to prevent it from
radiating radio frequency noise, it must be connected to the earth ground.
Max torque: 0.35-0.5 Nm (3.1-4.43 lb-in)
STEP 1
STEP 2
STEP 3
