QnUDE Ethernet – X2/BoX2 series
SUEN00403 2020-10
4 (8)
N
o
rm
a
l.d
o
tm
,
2
02
0
-0
9
-0
9
4
Setting in QnUDE Ethernet communication
The following chapter describes how to setup the Ethernet communication.
Adjust the Built-in Ethernet port open settings located in PLC-Parameter.
Enter IP address, Subnet Mask and (if used) Default Gateway.
Port no. in decimal.
Select protocol UDP and set station port number (setting range: 1025 to 4999, 5010 to 65534. Do not use port
5000 to 5009 since they are used internally by the system. For multiple HMI’s connected to one controller, use
a uniques port for each HMI to reduce the workload.
