18
FEEDBACK DESTROYER PRO DSP1124P
The fifth page of the MIDI menu shows the Store Enable flag represented by a capital S in the DISPLAY.
Available values are 0 and 1. If set to 1, the FEEDBACK DESTROYER PRO receives controller 18 as a
direct save command, i.e. the current settings will be stored without further confirmation in the preset number
that corresponds to this controller value. If set to 0, the DSP1124P ignores all incoming commands referring
to controller 18.
+
ATTENTION! Store Enable mode has been designed to transmit several presets as
conveniently as possible from an external PC to the FEEDBACK DESTROYER PRO. In this
mode, it is possible that stored presets will be replaced or altered if controller 18 messages are
sent via MIDI! We therefore recommend that you disable this mode as soon as the intended
data transfer has been completed. During power-up, this mode is automatically disabled
(mode 0).
On the sixth, and presently the last page you can access the System Exclusive functions, which is indicated
by a d (= dump) in the DISPLAY. To the left of this d, you can see a 0 if no sys-ex data can be received or
transmitted. When you enter mode 1, the DSP1124P will be able to receive sys-ex data. In mode 2, the
DSP1124P is ready to dump its entire memory contents with all parameter settings to an external MIDI storage
medium. Start your sequencer software, and press the STORE key. To load the data back, select mode 1,
and start your sequencer software to restore the settings in your FEEDBACK DESTROYER PRO.
If you press the IN/OUT key again on the sixth page, the FEEDBACK DESTROYER PRO quits MIDI mode.
You can also use any other key to leave the MIDI setup menu.
The full-featured MIDI implementation of the FEEDBACK DESTROYER PRO allows for easily integrating the
unit into any MIDI system.
s
MIDI IN
All MIDI data sent to the DSP1124P (sequencer, MIDI foot controller, etc.) are received via the MIDI IN jack. For
example, if you wish to use the DSP1124P as an effects device for your guitar rack, you can connect the
MIDI IN jack to a MIDI foot controller that allows for selecting program presets. If your rack includes another
MIDI effects device, the data sent from the MIDI foot controller can be passed on to that device through the
MIDI THRU port of the FEEDBACK DESTROYER PRO.
s
MIDI THRU
The MIDI THRU jack is used to loop through incoming MIDI data, i.e. any controller data received at the MIDI IN
of the FEEDBACK DESTROYER PRO will be transmitted via the MIDI THRU jack to other MIDI devices/
instruments.
s
MIDI OUT
The MIDI OUT jack allows for transmitting MIDI data that originate from the DSP1124P.
The FEEDBACK DESTROYER Design Editor software enables you to control the DSP1124P from an external
PC. What is more, you can use the FEEDBACK DESTROYER PRO to control the editor software, so that both
units communicate with each other. Download the editor free of charge from our web site at www.behringer.com.
10. INSTALLATION
10.1 Audio connections
As a standard, the audio inputs and outputs on the BEHRINGER FEEDBACK DESTROYER PRO are fully
balanced. If possible, connect the unit to other devices in a balanced configuration to allow for maximum
interference immunity.
10.INSTALLATION
Downloaded from www.g7syw.com
www.g7syw.com
