Behringer EUROPORT MPA200BT, Быстрый старт

Страница: 8 / 40

14
Quick Start Guide
15
EUROPORT MPA200BT
EUROPORT MPA200BT Controls
(1)
(3)
(5)
(6)
(9)
(4)
(7)
(8)
( 10 )
( 12 )
( 13 )
( 11 )
(2)
(1)
LCD SCREEN displays the current DSP module
and parameter settings.
(2)
ENCODER KNOB
toggles between Graphic
and Edit modes (when pressed) and changes
parameter values (when rotated).
(3)
SETUP
button steps through parameters
within DSP processing modules.
(4)
PROCESS button steps through the DSP
processing modules.
(5)
EXIT
button returns to the top-level DSP
screen when pressed.
(6)
ENTER button saves changes and deactivates
Edit mode when pressed.
(7)
WIRELESS SYSTEM LEDs
indicate wireless
microphone signal input.
(8)
WIRELESS SYSTEM USB input accepts only
the Behringer wireless microphone receiver.
NOTE:
The wireless USB input works in parallel
with the INPUT ½ analog inputs, which means
the wireless microphone signal can be heard
at the same time as audio coming in through
the INPUT ½ connections. We recommend you
unplug the INPUT ½ connections in order to
hear the wireless microphone signal alone.
(9)
MP3
audio jack accepts audio from phone or
media player using a 3.5 mm (1/8") plug.
(10)
INST/MIC IN combo jacks accept in put signals
over XLR balanced, ¼" TRS balanced, or ¼" TS
unbalanced connectors.
(11)
OUTPUT jack sends a combined signal
from all inputs (INST/MIC IN jacks, wireless
microphone, Bluetooth and MP3) out over a
balanced XLR connection.
(12)
POWER
switch turns the unit off and on.
(13)
POWER SOURCE
jack accepts the
included IEC cable.
Charging the battery
The MPA200BT ships with a rechargeable, internal battery that can power continuous audio playback for up to 20 hours. We recommend that you fully charge the battery before your
first use.
To charge the battery for the first time, follow this procedure:
1. Turn off the MPA200BT by pressing the POWER switch.
2. Connect the unit to an AC power outlet. The LCD screen will display to indicate the battery is charging.
3. Keep the unit plugged in to AC power until the LCD screen displays to indicate the battery has been fully charged.
NOTE: The MPA200BT uses a sealed lead-acid gel battery, and the battery will slowly self-discharge when the MPA200BT is not in use. Before storing the MPA200BT for an extended
period, fully charge the battery before storage, and then charge again every 3 months.
NOTE: The lead-acid battery needs to be recharged every 3 months for continued operation. Please replace the battery if the MPA200BT operating timenoticeably decreases,
even after a full charge cycle.
(EN)
Step 2: Controls