– 12 –
behr InKjel P
142109
Write a heating program
The InKjel P can be used to write up to 25 different
heating programs.
A program can have up to 20 program steps. For each
step you need to enter two values:
the heating power and
the time for which this heating power is to be
maintained.
When writing a program, always note its purpose
and the settings selected.
Select
==>>
in the Start menu
and select
Program
in the menu which then appears.
DEVICE
PROGRAM
<<==
01
You are now on the first page of the Program menu.
Select the entry box for the Program No.
Select the required Program No. You should select 01
if you have not yet written any other program.
PROG.NUMBER
<<==
==>>
01
Then select
==>>.
You will now see for every program step a page, on
which you can enter the settings for this step.
TIME
HEAT OUTPUT
Program
01/01
<<==
==>>
025
020
The Program No. and the Program Step No. which you
are currently editing are shown in the top line.
Program 07/05, for example, means the fifth step in
Program No. 07.
In the lines below, specify the values for this program
step:
the
Heat output
in % of total output (ranging from 1
to 100),
and the
Time
in minutes.
The unit will then heat at the specified percentage of
total heat output for the time specified.
You can enter the values digit by digit. If you make an
invalid entry (e. g. 150%), the device won’t accept this
entry but jump back to the first digit of this field.
When you have finished entering the data for this pro-
gram step, select
==>>
to proceed to the next step.
If you want to check the previous program step again,
select
<<==
. In the top line you can always see which
program step you are editing.
In this way you can make up a program with up to 20
program steps. Maybe you don’t want that many steps
for this program. In this case, just make sure that in the
steps you are not using the heat output and the time are
set to zero.
When everything is finished, select
<<==
several times
to go back to the start menu.