13
Recommendations
• After adjusting the camera installation, check that each knob is fully
tightened.
• Do not over tighten the screw wrench to avoid screw slip teeth.
• For very small camera and lens if you cannot reach the balance as
per anove steps, replace the camera or lens.
TIP
• Before starting the gimbal, make sure the camera is properly
mounted on the stabilizer and perfectly balanced.
• Beholder EC1 uses the latest 32-bit systems, a multi-processor
technology and inductive motor technology, with torque greatly
improved. Therefore, it's able to start and level the camera if out
of balance, but for the shot stability, battery life and power saving,
we strongly recommend you to find the best balance first and then
power the gimbal on and shoot the video.
2016 Beholder All Right reserved
