8
PV, LV: 13 cm
PGV, LGV: 13,6cm
1
2
1
2
INSTALLATION
Removing wall bracket:
Remove wall bracket from
heater by pressing lip 1 and
push lightly downwards on lip 2.
Pull the bracket out gently.
Protection and safety lid:
1. Remove the lid by pressing the two sides
together and pull out.
2. When placing the lid the mark shall point
towards the front of the heater.
5-15 cm
Min 2
c
m
PV,LV-PGV,LGV 10 cm
distance to loor:
f
10 cm
Recommended
Fixing the wall bracket:
Insert a screw in the lower key hole approx. 13 cm above the loor. Level the bracket and insert the other 3 screws. When the heater is
f
installed the distance below should be approx. 10 cm.
At the bottom of the back plate there are two
small triangle tracks. Place the heater onto the
tracks and push the heater towards the lips on
top of the bracket in an upright position.
Use of the heater
Heater sizes
Switch on the heater. The heater is factory set at 22 C. Scrolling the thermostat wheel changes the temperature setting. When the
selected temperature is shown for the irst time it will be displayed on the loor for 3 minutes. When adjusting the temperature later it will be
f
f
displayed for 10 seconds.
After a power outage or the power is switched off and then on again, the Wi-Fi symbol will be displayed on the loor together with the
f
temperature for 3 minutes. After a power outage the heater will restart at the set temperature.
GB
PV * Wi-Fi
LV * Wi-Fi
PGV * Wi-Fi
PGV
PV
33
50
83
404
33
56
89
423
PV: 29
PGV: 36
B2
A
C
B1
270
LGV * Wi-Fi
C
B2
B1
A
90
LV: 29
LGV: 34
33
50
83
204
33
56
89
223
LGV
LV
