52
24/7
If you hold the button for 10 sec. the heater will go back to factory setting, i.e. the stored
programme will be deleted and the heater will start calibrating for a new temperature profile.
The setting of the thermostat wheel will prevail.
Tap on the
onnecting (1) button and the white light will be on for 10 sec. if it initially was
C
dimmed down. This is useful if the room is bright.
When connecting the heater keep your finger on the button for 3 sec. until the blue light
blinks.
When a heater is selected in the app and the phone is within the range of the heater the blue
light on the heater will switch on.
or
can be changed.
TEMPERATURE
PROGRAMME
The blue light will blink three times when re-setting the heater.
The white light on the heater is on when the heater is controlled from the app.
When the heater is controlled from the app any command from the app will make the white
light on the heater be on for 10 sec. Then the light intensity will be reduced.
The white light will blink three times when re-setting the heater.
TECHNICAL INFORMATION
THE HEATER CAN BE USED MANUALLY AND WITHOUT APP PROGRAMMING
The selected programme in the app will be sent to the heater when pressing
The
STORE CHANGES.
programme will be stored in the heater electronics.
When changing phone heaters must be linked up again.
When connecting a heater to the app the phone must be
the heater.
within reach of
Re-setting of the heater to factory setting, only when the heater is transferred to a new owner.
The thermostat can be set at minimum 5°C.
The red light in the thermostat wheel is on when the heater is heating.
The App will be automatically updated provided the phone is set at automatic updating and the phone is
connected to a router.
If the phone is outside of the range of the heater, the hea
cannot be controlled from the app but
ter
it will
follow the app programme.
In the opening page of the app the Bluetooth signal strength is indicated for each connected heater.
Heaters within the Bluetooth range are shown in black letter, the ones outside in grey.
Heaters can be connected to multiple users.
BEHA Heaters with steel front have protection class IP24 and can be installed in bathrooms and laundry
rooms I accordance with local norms.
By power outage:
Without app:
T
set
he heater returns to
temperature.
With app:
The heater will go to the programme and setting it had when the power outage happened. To get back
to present time each heater has to be opened in the app
hen tap on
The heater will receive
,
. T
SAVE CHANGE.
correct time setting from the app.
Cold draft/Open window function:
When opening a window and the temperature drops more than 5°C within 40 sec the cold draft function is
activated. The heater changes between
temperature for 10 seconds, and 5
for 30 seconds. The function is
set
°C
active for max. 15 minutes.
GB
Содержание LB
Страница 46: ...46 BEHA Bluetooth APP GB 50 NO 47 ...
