7
Image Capture/Laser Pointer
Figure 1.2
O
C
O
C
The product will be in measurement mode upon power on. Press the trigger to
capture an image and to use the laser pointer to help aim on the target surface
(laser pointer must be enabled in the menu, see Figure 2.3). Press navigation
button to the left to save the image or press to the right to cancel .
Note: The laser is used for aiming purposes only and is not related to temperature
measurement.
Hold the product 30 cm (12 inches) from the target (>15
O
C / 59
O
F) and 6 cm
(2.4 inches) from the target (<15
O
C / 59
O
F) for best temperature accuracy.
Note: Higher Distance to Spot ratios require smaller target areas to make
accurate measurements. The Distance to Spot ratio of this product is 20:1.
Image Blending
Figure 1.3
0%
25%
50%
75%
100%
UP
UP
UP
UP
UP
O
C
O
C
O
C
O
C
O
C
Blending may be adjusted for an easier interpretation between infrared
and visible images. To change the level of blending between 0 - 100%, press
down or up on the power button while in measurement mode.
