Bego 26480, Руководство по эксплуатации

Страница: 24 / 33

24
86
10
7 B
A
-en
/0
1
English
⋅
Fornax
®
T
en
Melting
Ideally, the melting process should always be
carried out at the max. setting (knob to 100%)!
In isolated cases, the premelting and melting
process may be carried out with a reduced setting.
The corresponding values must be individually
determined by the user and can be entered into the
table on page 26. The corresponding procedure
also applies for non-Bego alloys.
Melting procedure
When the last solid part has sunk completely into
the melt, continue to heat as long as is indicated in
the table on page 26!
After the end of the further heating time casting can
be carried out, provided that the melt is ready for
casting after a visual check. The time needs to be
used for an exact setting of the continuous heating
time during the melting process.
1. Align the crucible with the center of the crucible
coil by turning the casting arm and moving the
the slider back and forth.
2. Lift the crucible coil. Pull the handle located on
the right exterior side of the device forward for
this purpose.
3. Insert the preheated mould into the mould
holder. The pouring spout of the mould must
face towards the crucible (page 21/22).
4. The melting process is started by closing the
cover.
The "heating" button will light up to indicate
that the heating process is in progress
5. For the melting process, turn the knob to the
max. heating setting (100%) or to the individu-
ally determined heat output, respectively.
6. Look through the protective lens to observe the
melt.
7. Start the timer (with the continuous heating/
holding time entered in the casting table page
26) when the last solid part has completely
sunk into the melting bath.
8. An acoustic signal (beep) will sound when the
time set on the timer has expired.
NOTICE
Important!
The motion of the melt is caused by the magnetic
field, not by the heat. The moving melt is
therefore not a "boiling" melt!
WARNING
Never look into the melt without
protective glass and protective
eyewear!