Bego 26480, Руководство по эксплуатации

Страница: 15 / 33

English
⋅
Fornax
®
T
15
86
10
7 B
A
-en
/0
1
en
Cooling
Switch the device on and open it (see page 16) The
indicator light stays on permanently if the coolant
water level of the device is sufficient (if not, error
message E13 will appear).
1. Allow the unit to cool down without turning it off
in case error message E 23 is displayed..
2. Open cover.
3. Remove the stopper from the cooling water
tank.
4. Add potable water to approx. 2 cm below the
rim, using a suitable container (e.g. bottle, jug).
5. Finally, replace both stoppers.
6. Keep a suitable container (2) handy to drain
excessive water.
7. Press the upper ring of the quick connector (1)
located on the bottom right of the rear unit
cover down.
8. Pull the stopper (3) out and collect the water
draining from the tank.
9. Replace the stopper.
NOTICE
It is important to watch the fill level of the cooling
water tank when adding water as the unit does
not have a level indicator.
Mode
l No.:
S/N:
26425
3590
01
230 V
50/60 H
Z 4100 V
A
Manufact
ured:
2012
W 45
Schutz
art: IP
21 KB
5min
WARNING
Risk of burns!
The water can reach temperatures up
to 70° C if the unit was used for
casting beforehand!
NOTICE
After initial commissioning, run the device for at
least 2 minutes to allow for the cooling water to
circulate and check the water level again.