BEFCO RS2-04L, Руководство оператора

Страница: 11 / 48

3.02 - Setup
Notice to dealer: Pre-delivery setup and service including lubrication is the
responsibility of the authorized dealer. It is up to him to assure that the machine is in
perfect condition and ready to be used. It is his responsibility to ensure that the
customer is aware of all safety aspects and operational procedures for the implement.
He must also fill out the Pre-Delivery Checklist
3
prior to delivering the implement.
3.03 - Assembly Instructions
36 30 24 Washer external lock Ø10 Z
36 30 24 Nut HH M10-1.50 C6 Z MD
36 30 24 Bolt HH M10-1.50x25 C8.8 Z F
Hardware bag contains:
6 5 4 Rake wheel
1 1 1 Frame holder hitch assembly
1 1 1 Three point hitch base w/foot stand
1 1 1 Top link support
1 - - Support arm, rear section RS2-06
1 - - Support arm, front section RS2-06
- 1 - Support arm RS2-05
- - 1 Support arm RS2-04
- 1 - Arm w/hub (1 wheel) RS2-05
3 2 2 Arm w/hub (2 wheel)
RS2-06 Qty. RS2-05 Qty. RS2-04 Qty. Description
Each unit is shipped as a kit that consists of the following:
Note: All hardware needed for assembly will be found either on the machine or in the
hardware bag. Assembly will be easier if all parts are loosely assembled before
tightening the hardware.
CAUTION: Stand clear of bands when cutting as they could be under sufficient
tension to cause them to fly loose. Take care in removing bands and wire. They
often have extremely sharp edges and cut very easily.
To assemble RS2-04, RS2-05 and RS2-06 hay rakes do the following (see fig. 3) :
1. Remove the top hitch support from the three point hitch base.
2. Slide the frame holder hitch on to the three point hitch base.
3. Install the top link support over the frame holder hitch and secure it using the
M14x100 bolt, the Ø14 lock washer and M14 nut to tighten it.
4. Lock the frame holder hitch to the three point hitch base by inserting the Ø16x178
locking pin through the hole used for transport on the frame holder hitch and secure
it using the Ø4 hairpin cotter.
5. To facilitate further assembly, use a hoist to attach the three point hitch of the hay
rake to the three point hitch of the tractor. Secure the top link with the top hitch pin
and the Ø4 hairpin cotter and the bottom hitches with lynch pins.
O
PERATION
11
BEFCO
H
AY
R
AKES
O
PERATOR
’
S
M
ANUAL
3
See Chapter 7 - Pre-Delivery Checklist.