BEFCO BRB-284, Руководство по эксплуатации

Страница: 18 / 40

CAUTION: Depending on the size of the tractor, you may not be able to tilt the
blade and still be able to raise it high enough to clear the ground during
transport.
Offset adjustment (see fig. 8):
The rear blade can be offset to the right or to the left up to 37.5° (or 21”) by removing
the pin on the adjusting brace
(see #13, fig. 3) and the pin on the moldboard assembly
O
PERATION
18
BEFCO
R
EAR
B
LADES
O
PERATOR
’
S
M
ANUAL
Fig. 8 - Offset adjustments.
Blade shown at 0 degrees offset.
Unit can be offset in 7.5 degrees
increments up to 37.5 degrees,
right or left of center.
right left
male brace
female brace
Note: Male brace must be
attached to A-Frame; female
brace must be attached to
moldboard assembly.
In order to maintain the moldboard perpendicular
to the direction of travel, insert brace pin and
moldboard pin in the same position number
Male brace attached to left side
of A-Frame.
Male brace attached to right side
of A-Frame.
Pin position on moldboard
Pin position on moldboard
Drawing A - Right offset
Drawing B - Left offset
according to the drawings below:
Pin position on male brace
Pin position on male brace
0 deg. / 0" offset Position 1
7.5 deg. / 5" offset Position 2
15 deg. / 9" offset Position 3
22.5 deg. / 13" offset Position 4
30 deg. / 17" offset Position 5
37.5 deg. / 21" offset Position 6
0 deg. / 0.00" offset Position 1
7.5 deg. / 5" offset Position 2
15 deg. / 9" offset Position 3
22.5 deg. / 13" offset Position 4
30 deg. / 17" offset Position 5
37.5 deg. / 21" offset Position 6