Befaco JOYSTICK V1, Инструкция по сборке

Страница: 2 / 6

JOYSTICK V1 - ASSEMBLY GUIDE – Rev. Feb 18
FERRITE
Solder the two ferrite beads by using a recycled resistor leg passed through each ferrite and
proceed as if it were a resistor. Ferrite beads don't have polarity.
Qty Name on PCB
2
, FERRITE-
OPEN THE ICS BAG
ICs
First place the sockets (taking care to orientate them properly – the notch or dot on one
end of the IC should match the image on the silkscreen) and solder them into their correct
positions.
Next place the ICs in their respective sockets (again taking note of their orientation – the
notch or dot on the top of the IC must match that of the socket and silkscreen).
Qty Value
Name on PCB
6 TL072 IC1, IC2, IC3, IC4, IC5, IC6
CAPACITORS
Identifying capacitors can be quite tricky. Codes stated are indicative, please take a look at
this guide for help identifying capacitors: http://www.wikihow.com/Read-a-Capacitor
Qty Value Code Name on PCB
10 100nF 104 C1, C2, C3, C4, C5, C6, C7, C11, C12, C14
2 47nF 47nk100 C8, C13
ELECTROLYTIC CAPACITORS
Values are written on the side of the capacitor. Mind their polarity (The long leg of the
capacitor is the positive (+)).
Qty Value Code
Name on PCB
2 10uf 10uf C9, C10
POWER CONNECTOR
Solder the power connector where it says “EPOWER” ensuring the position is correct: it must
be placed over the silkscreen marking with the small triangle on the connector on the same
side as the thick white line on the PCB.
2