BEER GN-2/1, Руководство по эксплуатации, Страница: 10 / 27

Beer Grill AG Beer Grill GmbH
Allmendstrasse 7 Tel. +41 (0)56 618 7800 Körnerstrasse 14 a Tel. +49 (0)71 61 659 876 info@beergrill.com
CH
– 5612 Villmergen
Fax +41 (0)56 618 7849 D
– 79539 Lörrach
Fax +49 (0)71 61 659 879 www.beergrill.com
Page 10
8 Connecting of the Hot Cube appliances
8.1 Electrical connection
Connection and start-up have to be done by a skilled/trained person only. For connection of
the Hot Cube proceed as follows:

Check up if electrical data of mains correspond with those on the rating plate of the Hot
Cube. The type plate is located on the bottom right behind the water drainage channel
[1]. A second type plate is located on the right inside the lower control unit.
NOTE: You will find a copy of the associated electrical scheme (No. 23Ea050-00) in the
appendix.

Connection to conform to IEC resp. CEI 335-1 and local regulations, i.e. fit the mains
plug to the oil-resistant connecting cable that is heat-resistant up to 90 °C, and connect
to a mains socket. For a permanent connection, an all-pole main switch with at least
3 mm contact clearance is to be provided.

Hot Cube has to be connected to a potential-equalisation system (conform to VDE 0700,
part 36/IEC 335-2-36).

The electric socket must be accessible after mounting or installation of the equipment.
Replacement of the cable must be carried out only by the manufacturer, service
technician, or authorized dealer.
Stainless steel is not totally resistant to substances containing chlorine or
acids. These may corrode the equipment's materials. The appliances must
not get in contact with such substances.
!