Beem G-1030ST-E-CERAMIC, Инструкция по эксплуатации

Страница: 21 / 56

BEEM – Elements of Lifestyle
21/56
5. Fill the water tank with approx. 1 l of water, up to the MAX mark at the most. The
water tank may only be filled with water. Never fill with other liquids. For extremely
hard water, we recommend a mixture of 50% tap water and 50% distilled water. Do
not add vinegar, additives or descaling agents or other chemicals.
6. Reinsert the filter cartridge in the water tank.
7. Push the water tank into the rest until you feel it snap in (click).
8. Place the iron on the rest of the steam generator.
9. Switch the steam generator on by pressing the button. The red indicator on the
steam generator lights up and indicates that the utensil is switched on. It goes out
again when the utensil is switched off. At the same time the Heat indicator lights up,
indicating that the utensil is heating up.
10. Set the temperature of the iron to at least wool/silk. The temperature control lamp of
the selected level flashes. As soon as the set temperature is reached, the display
lights continuously.
11. When switching on, the steam volume regulator is automatically in the Low position.
Do not set a higher level yet.
12. Wait until the Heat indicator on the steam generator goes out.
NOTE: The indicators switch on and off frequently during ironing when the
utensil reheats.
13. Switch the steam volume regulator to High and wait again until the Heat indicator
goes out.
14. Press the steam pressure button for about 20 seconds. Wait 30 seconds and press the
steam pressure button again for 20 seconds. The steam generator system is cleaned,
air pumped out and water pumped into the system. You will hear a loud vibration and
pumping noise which quickly disappears as soon as the air has been evacuated from
the pipes. This may take 1 or 2 minutes. The pumping noise during operation is
normal.
15. Always operate the utensil with the low steam volume of level Low for about 2
minutes at the start before setting to the higher Middle or High levels.
6.2 Steam ironing
1. Prepare the utensil as described in 6.1.
2. After preparation, leave the steam volume on Low or select the desired steam
volume Middle or High.
3. Set the desired temperature on the iron. You can start ironing when the temperature
control lamp on the iron lights continuously.
4. Set the iron to level • to switch off and replace it on the steam generator.
5. Press the button on the steam generator and then pull out the mains plug.
6. Empty the water tank as described in chapter 8.
6.3
Vertical steam ironing
Vertical steam ironing is particularly suitable for hanging items of clothing (coats, jackets,
suits), curtains and for removing creases.
1. Prepare the utensil as described in 6.1.
2. After preparation, leave the steam volume on Low or select the desired steam
volume Middle or High.
3. You obtain the maximum steam emission when you set the steam volume regulator
on the steam generator to High and the temperature of the iron to the MAX
position.
4. Hold the iron vertically 5 cm to 15 cm away from the item to be ironed and press the
steam pressure button. Move the sole of the iron continuously up and down over the
material.
5. Keep the steam pressure button pressed for 1 minute at the most. See the
instructions for the steam iron.
6. If no more steam emerges, wait until the heating indicator on the steam generator
goes out.