14
BURNER OPERATION
BURNER OPERATION
Control functions
Before lighting the burner:
• Check that all hoses and gas fittings are tight�
• Remove or pivot lid to open�
NOTE: The lid is designed as a cover for weather protection�
The lid is not designed to be used as a cooking hood�
• Check control knob is in the ‘OFF’ position�
• Ensure that the cooking surfaces are clean�
• Ensure that the gas isolation valve or the LPG
bottle are ‘ON’�
Lighting instructions
• Do not attempt to light burner with the cooking
surfaces covered�
• To light burner, depress the knob and rotate
to ‘BOOST’�
• If burner did not light, turn knob to the ‘OFF’ position�
Allow gas to disperse, then repeat lighting procedure�
Manual lighting
• If, in the event of the ignition system not working,
the burner can be lit manually�
• Rotate the knob to the ‘BOOST’ and place
a lighted match near to the burner�
• If the unit does not operate correctly refer to the
troubleshooting section on page 18�
To turn the burner off
• When cooking is complete, rotate the knob fully
clockwise so the pointer on the knob is positioned at the
off position�
WARNING!
Ensure the cast trivet is in the correct orientation with
the 4 feet on the trivet located into the recess in the hob� The
height of the trivet is critical for burner operation�
Operating the side Side Burner
Do not use oversized cookware or place cookware off-centre
over the burner as this can cause high temperatures in
control knob and surrounding panels�Cookware should be a
minimum of 120mm diameter and should not exceed 300mm
diameter, the use of larger cookware may cause damage to
the appliance and is not covered under warranty�
Correct
P
Incorrect – pan too
large
Incorrect – pan not centred.
Incorrect – flame to high
