Beef Eater SL4000S SERIES, Руководство по сборке и эксплуатации

Страница: 6 / 24

6
ASSEMBLY OF MAIN BARBECUE
Fit The Burners
Remove the ‘R’-shaped retaining clips from the burners�
Fit the burners, open end first, over the stem of the control
valves at the front of the barbecue� Lower the other end of
the burner so the lug locates into the corresponding hole at
the rear of the barbecue�
Replace the retaining clips into the burner lugs so the
burners stay in position�
Fit The Vaporizers
The Vaporizers are designed to vaporise fats and juices from
the meat� The Vaporizers reduce flare-ups and help to add
that great barbecue flavour� One Vaporizer is fitted over each
burner that is located under the grill�
The tabbed ends of the Vaporizers face forward to the front
of the barbecue frame� The tabs fit into the slots in the front
end of the barbecue behind the control panel� The Vaporizers
should be fitted to the same side of the barbecue as the
grate� They will not work if fitted under the plate�
Fit Cooking Plates And Grates
You should fit the plate to the left-hand side of the barbecue
frame (with the drain hole to the extreme left)� The grates are
fitted to the right hand side
of the barbecue frame� The temperature gauge on the
roasting hood has been calibrated for this arrangement of
plate and grate�
NOTE: The grates must always be positioned over the
Vaporizers�
The 5 burner model (4 main burners plus a side burner)
comes standard with a 320mm plate, a 320mm grill and a
160mm grill� You may use other combinations of cooking
surface, however, the plate may cover no more than 50% of
the total cooking area�
The 6 burner model (5 main burners plus a side burner)
comes standard with one third plate and two thirds grate and
is approved for use with a maximum of two thirds plate�
Do not cover the entire surface of the barbecue frame
with plates as this will cause severe heat damage to the
appliance�
ASSEMBLY OF MAIN BARBECUE