5
5
5
Join Top and Middle Poles
You will need:
Pre-assembled parts from Step 1 (ring + bac top pole)
Pre-assembled parts from Steps 2 - 4 (assembled base + bottom pole + middle pole)
1 x Bolt, Nut & Washers D (M8 x 60mm)
1 x Plastic Handle (Bolt E)
Be careful as your base is not yet weighed down.
Join the Top and Middle Pole inserting one Bolt, Nut & Washers D through the regular hole. Then insert Bolt E
(plastic handle) into the hole with the external nut, as shown in the pictures.
6
6
Complete Your Stand
Tighten all your nuts once again to make sure everything is secure and
your stand is complete. If you haven’t already done so, follow the instructions on
filling your base to ensure it is weighed down correctly.
Adjusting Your Basketball Stand
To adjust the height of your basketball post
simply loosen the plastic handle (Bolt E) and remove the bolt
(D).
Slide the top pole to the desired height. Tighten these bolts to
secure the pole in place.
Join Middle and Bottom Poles
You will need:
Pre-assembled parts from Step 1 (ring + bac top pole)
Pre-assembled parts from Step 2 & 3 (base + bottom pole + base struts) Parts 6 and 6a (Middle Poles)
2 x Bolt, Nut & Washers D (M8 x 60mm)
Join the Lower Middle Pole (part 6a) to the Bottom Pole in the pre-assembled base using one Bolt, Nut & Washers
D. Then join the Upper Middle Pole (part 6) to the top of the assembly with another Bolt, Nut & Washers D.
4
4