OPERATIVE INSTRUCTIONS
____________________________________________________________________
7.4.5
Assembly the Rotor and the connecting rod.
Reassemble the Rotor (199) and the joint in reverse order (see point 7.4.4). During these
operations keep attention for the joint’s lubrication. Insert the pin (403) from below and
start to fill the joint with oil, let the air flow out and push up the pin (403) to the upper edge
of the joint. Seal the joint with the ring cover for bell (435) and block it with the elastic ring
(775).
Regarding the joint – drive shaft side – use the same method described above (7.4.5)
7.6
Disassemble and assembly the mechanical seal.
7.6.1
Disassemble the rotary mechanical seal faces.
www.bedu.eu
