Start
8 (Cabinet End Panel)
Edge Strip
16
16
16
16
20
20
20
20
20
20
20
20
20
20
Finish
1
Step 9
Assembling right end panel
It is recommended to insert small
amount of glue in the dowel holes
in the rails (4b) & (6) and clean
the excess glue with a damp cloth.
Making sure, that, all the hardware
pins and dowel holes in the left
cabinet end align with the above
assembly and edge strip faces
toward the front of unit, gently press
the left cabinet end down so that it
is completely pressed up along the
shelves and rails (no gap). Lock the
cams (16) in position by rotating
clockwise 180
0
, using Allen key (23).
Step 10
Attaching MDF back panel
Lay unit face down on a protected surface to avoid damaging melamine edges and position the back panels (7)
against the top rear of the unit (approximately 1.5 mm in from the top edge) with white side facing inward. The gap
between both the back panels would be approximately 1 mm.
Ensuring that the cupboard is square, nail the back panels (7) along all the edges taking care to avoid nail
breakage through the surface of the fix shelves, cabinet ends and division panel.
Fix the cover caps (19) on the cams (16).
Page 7 of 10
