Becx Machines WLA60, Руководство пользователя, Страница: 17 / 23

Loader arm
Type: WLA60
Version: 1
July 2019
Page 17 van 23
6.
Maintenance

Only components supplied or approved by the manufacturer must be used for
replacement or repair of parts.

Always disconnect the loader arm from the feed lines when work is carried
out on the machinery. This is done by disconnecting the rapid attachments.

Only persons who can show that they have adequate knowledge of
mechanical and hydraulic machinery through their training and experience are
allowed to carry out maintenance work.

The installation can be cleansed with a high pressure cleanser, never point
directly at hydraulic components.
Weekly maintenance
No. What to do Action Result
1 Tightening bolts

Check and tighten all bolts
2 Visual check

Visually check the construction and hydraulic
aggregate for damage and cracks.

Check cylinder-rods for damages and dirt.
3 Wear strip check

Check if the strips are worn onto the bolt
heads (see chapter 3.3), if so, replace all 4
strips.
4 Grease

Squeeze grease into the grease nipples. These
are located at all pivot points.

See 1 Technical data for type
Annual maintenance
No. What to do Action Result
1 Inspect Check following parts for damage, cracks and
looseness:

Connections.

Hoses.

Couplings.

Pivot points.

Wear strips.