Beckhoff CX2500-0070, Руководство пользователя

Страница: 12 / 26

Mounting and wiring
CX2500-0070 12 Version: 1.1
3.3 Attaching the system interface to the CX20x0 system
Opening the PCI Express bus cover
The system interfaces for the CX20x0 system are connected via the internal PCI Express bus, which has a
protective cap. The cap can be removed with a screwdriver. To this end insert the screwdriver into the recess
in the short side (see diagram) and lever off the cap. The bus connector is then accessible, as shown in the
diagram.
Once the bus connector is accessible, the module can be attached on the left-hand side.
The module audibly locks into place.
Further modules can be connected to the system in the same way. Once all modules are connected, the
system is placed on the DIN rail as a block. For details please refer to the section on DIN rail mounting.
Maximum number of system interfaces
Up to four system interfaces can be attached on the left-hand side of the system.
3.4 Installation on the mounting rail
Snapping onto the mounting rail
The CX20x0 can simply be snapped onto the mounting rail. The bar clips are inserted on the top side and
underside Then simply position the block on the mounting rail and push it slightly until it engages on the
right-hand side. This is indicated by a distinct click. The bars are then engaged again. The engagement of
the individual bars is indicated by a distinct click.