Beckhoff CP32-1600 Series, Руководство пользователя

Страница: 25 / 56

Commissioning
CP32xx-1600 25 Version: 1.0
4.2 Assembly
The Panel PC CP32xx-1600 is designed for installation on a mounting arm system. Please observe the
environmental conditions prescribed for the operation (see Chapter 9
Technical data [ } 50] ).
The Panel PC is installed on the mounting arm system using a mounting arm adapter. At the rear of the
Panel PC there are four M6 threaded holes spaced 100 x 100 mm apart and four M6 threaded holes spaced
70 x 130 mm apart for installing a mounting arm adapter. The following ordering options are available, if you
require a Beckhoff mounting arm adapter for the installation.
Table 21: Mounting arm adapter ordering option
Order identifier Version
C9900-M761 Rotatable and tiltable mounting arm adapter for CP32xx-16xxx, clamping lever
to lock the tilt
Figure 13 shows the available mounting arm adapters. It has a locking screw to prevent twisting and a
clamping lever with which you can lock the tilt. The mounting arm adapter can be rotated by +/- 165°. The
adapter adapts the Panel PC with a 48.3 mm circular tube.
Fig. 13: CP32xx-1600_mounting arm adapter
You must install the adapter yourself. The procedure is shown below. The cable is routed through the
mounting arm.
For more information on the mounting arm adapter, please refer to the corresponding data sheet.
Installing the mounting arm adapter
If you have chosen the above-mentioned mounting arm adapter from Beckhoff, you must decide before
mounting whether you want to align the device upwards or downwards (see Fig. 14).