Becker Traffic Assist Pro Z 250, Руководство по эксплуатации

Страница: 29 / 117

29
GENERAL OPERATION >>>
> D
> GB
> F
> I
> E
> P
> NL
> DK
> S
> N
> FIN
> TR
> GR
> PL
> CZ
> H
> SK
Adjusting the unit bracket
The support plate (6) can be swung in two
directions (horizontally and vertically). It
can thereby be set at virtually every angle
of vision to the driver.
Vertical movements
>
Loosen the fastening screw (2) far
enough to be able to swivel the carrier
plate (6) downwards from above with-
out using excessive force.
>
Hold the base (5) with one hand and
swivel the carrier plate (6) to the desired
position with the other hand.
> Tighten the fastening screw (2) suffi-
ciently so that the Traffic Assist Pro is
held securely in place when the vehicle
is in motion.
Horizontal movements
> Loosen the fastening screw (1) far
enough to be able to swivel the carrier
plate (6) from left to right without ex-
erting excessive force.
> Hold the base (5) with one hand, and
swivel the carrier plate (6) to the desired
position with the other hand.
>
Tighten the fastening screw (1) suffi-
ciently so that the Traffic Assist Pro is
held securely in place when the vehicle
is in motion.
Adding the Traffic Assist Pro
The Traffic Assist Pro is equipped with
four guides and the carrier plate (6) has
corresponding retaining lugs.
>
Position the Traffic Assist Pro with the
guides on the carrier plate retaining lugs
(6).
> Push the Traffic Assist Pro downwards
to the stop.
>
Position the Traffic Assist Pro with the
attachment points on the bottom of the
housing on the carrier plate (6).
> Press the Traffic Assist Pro onto the car-
rier plate (6) without using excessive
force until the clip (7) engages in the at-
tachment point.
Removing the Traffic Assist Pro
Press the clip (7) on the unit holder with
one finger and remove the unit from the
unit holder using your free hand.
Note:
Do not swing the support plate in both
directions at the same time! Before mov-
ing, always take the Traffic Assist Pro off
the unit bracket.