Becker KNX/SMI Actuator REG-3TE 16K BT, Руководство по установке

Страница: 3 / 6

3
ARNING W
Never randomly press the push button on
the app without having a line of sight to the
sun shading system.
Fig. 2 Smartphone app
The manual override operation, a push button on the
device, has the highest priority and overrides all KNX com-
mands (even the safety objects).
The operating behaviour corresponds to the "KNX behav-
iour":
Brief push of the button = Stop
Long push of the button = Move
WARNING
Never randomly press the buttons on the
keypad without having a line of sight to
the sun shading system.
Programming
You can perform programming either in the app or directly
on the device.
There is a Prog button for programming and a display LED
both in the app and on the keypad (see Fig. 3).
The procedure here is basically the same:
Press the programming button in the app or on the
device (Fig. 3) to put the device into programming
mode. The red LED lights up when programming mode
is active. Programming is performed using the ETS on
the PC. This software ends the programming mode
automatically. The red LED goes out.
If the programming mode is to be ended earlier, press
the programming button again. The red LED goes out.
Fig. 3 Cover plate
LED flash patterns
Communication
LED green
Error
LED
red
Statement
Flashes
irregu-
larly
X
SMI communication,
no fault
Flashes
irregu-
larly X
SMI communication,
faults occur (the LED
is deactivated during
the motor search &
initialisation)
Lights
up con-
stantly
X X
Unparameterised - SMI
bus not yet commis-
sioned or no motors in
the internal motor list
Maintenance
There are no parts inside the device that require mainte-
nance.
Cleaning
Clean the housing with a soft, dry cloth. Do not use deter-
gents, cleaning agents, solvents, abrasive substances or
steam cleaners!
Liability
Failure to comply with the product information in these in-
structions and any use of the device other than its intend-
ed use may result in the manufacturer refusing to honour
warranty claims for product damage. In this case, liability
for secondary harm to persons or damage to property will
also be excluded. Observe the information in the operating
instructions for your sun shading system. The automatic
or manual operation of the sun shading system while iced
over and the use of the sun shading system during severe
weather may cause damage and must be prevented by
the operator through suitable precautions.
Obligations for the disposal of electrical devices
A marking with this symbol indicates the following
obligations under the scope of legal regulations:
The owner of this electrical device must dispose of it
separately from unsorted municipal waste for further
recycling.
Used batteries and accumulators that are not enclosed
in the old device, as well as lamps/bulbs that can be
removed from the old device without breaking, must be
disposed of separately.
Distributors of electrical devices and disposal compa-
nies are obliged to take back the equipment free of
charge.
The owner must take it upon themselves to delete any
personal data contained in the electrical device prior to
disposal.