Becker Centronic VarioControl VC320, Руководство по сборке и эксплуатации

Страница: 33 / 76

Overwriting the master
Switch off the power supply to the radio receiver for 10 seconds, then switch it
back on.
▻ The radio receiver remains ready for programming for 3 minutes.
To ensure that the new master transmitter is programmed in
the desired radio receiver only, all other receivers which are
connected to the same power supply must be deactivated
from the programming mode. To do so, after switching back
on the power, execute a drive or stop command using the
transmitter for the given receivers.
Now press the programming button of the new master transmitter for 10
seconds.
▻ The receiver confirms.
►
The new master transmitter is now programmed and the old master
transmitter deleted.
Programming the run times
Programming of the run times is only possible with transmit-
ters which support the function "MemoControl".
Each radio receiver can save one switching time for one UP and one DOWN
cycle.
In the " " slide switch position, this shading solution action is repeated every
24 hours.
It does not matter what position the / slide switch is in when programming
the switching time. Any stored switching times are overwritten.
1.
Run the shading solution to the opposite limit position if necessary.
2. Wait until the time at which the automatic run command is to be carried
out.
3. At the desired time, press and hold the relevant direction button until the
drive briefly stops after approx. 6 seconds and then continues to the limit
position.
4. You can now release the direction button.
The receiver has saved the current time for this direction of travel.
33 - en