bebeduE HAKKA, Инструкция по эксплуатации

Страница: 32 / 72

32
UK
3. This is a universal child safety seat and satisfies stricter regulations that those that
were applied to previous designs which were not rated universal.
4. If in doubt, consult the child safety seat manufacturer or supplier.
May only be installed in vehicles with 3 static points, 3 retractable points, approved by
the UN/ECE Regulation No. 16 or other equivalent standards.
EXTREMELY DANGEROUS: Do not use this seat on a passenger seat equipped with
frontal (SRS) airbag.
Use of the car safety belt (seat belt) is obligatory
WARNING: The car seat must never be placed on a seat with a frontal (SRS) airbag.
The car seat may only be installed using a three-point lap and diagonal belt on the car’s
front or rear seat.
INSTALLING THE GROUP 0 IN A CAR
Put the group 0 seat, facing backwards, on a passenger seat which has a three-point
seat belt. The carry handle must be the 1st position.
This product may be installed on seats with three-point seat belts which have two parts
(lap and shoulder).
Place the baby car seat facing backwards on the seat, i.e. with the rear part facing
forwards (Fig.36). The carry handle must be locked in the vertical position, as shown in
the picture.
Pass the central part of the seat belt over the front part (foot end) between the shell and
the two belt hooks, as shown in the picture (Fig.37).
Put the chest part of the seat belt around the car seat and pass it through the belt hook
at the rear, as shown in the picture (Fig.38).
The retaining hook holds the belt to the seat, as shown in the picture (Fig.39).
Fasten the seat belt tag in the buckle. Make sure it is not doubled over. Tighten it as
much as possible. Check again that the belt runs correctly through the three blue hooks
(Fig.40)
INSTALLING THE GROUP 0
This Group 0 seat must only be installed in BebéDue Hakka pushchairs.
First open the pushchair and engage the rear wheel brakes.
Recline the pushchair’s back support to the prone position.
Installing the group 0 in the pushchair
As shown in the picture (Fig.41), first remove the front bumper bar and fit the Group
0 adaptor into the base of the front bumper bar. Picture 42 shows it already fixed in
place. Finally, pick up the Group 0 and align it with the adaptors (Fig.43); push the car
seat downwards until you hear a click (Fig. 44).