INSTRUCTION MANUAL
WHEELSET
Pump the tires up to their maximum approved pressure. The lower
of the pressures specified for the rim or tire applies (Details can be
found in the enclosed tire pressure information or at www.beast-
components.de/service). Check the tire seat. The tire must contact
the rim evenly around its entire circumference. Have the tire seat
checked by a professional if in any doubt. If necessary, reduce the
tire pressure to the desired operating pressure.
tubeless tape wide
RR40
22 mm
RS25, RX25, RX40, RX60, RX80
23 mm
GR40, GR25, XC25
27 mm
XS30, XC30, TR30, ED30, DH30,
32 mm
HY35
37 mm
minimum valve
length
RX80
91 mm
RX60
71 mm
RX40, RR40, GR40
51 mm
RX25, GR25, XC25, XC30, TR30, ED30,
DH30, HY30, HY35
36 mm
XS30
31 mm
ASSEMBLING THE CASSETTE
Choose the cassette suitable for the freewheel XD, XDR, Shimano
HG, Microspline or Campagnolo and assemble the cassette
according to the manufacturer‘s instructions.
BRAKE DISC
Assemble the brake disc according to the manufacturer‘s
instructions.
WHEEL
Ensure that the hub sits on the stop in the end of the dropout.
Observe the instructions provided by the manufacturer of the
quick-release clamp or the quick-release axle.
Check that the wheel is attached correctly before each ride.
MAINTENANCE AND CARE
Please always make sure that your Beast Components product is
intact before each ride. Damage can cause the component to fail,
resulting in serious injury or even death. Damaged components
should never be ridden on and should be replaced immediately. If
you are in doubt, contact us or a experienced specialist.
The following aspects should always be taken into account:
Task
Interval
Check Tubeless Tape for damages
every 6 months
Replace the Tubeless Tape
every 12 months
Check spoke tension, runout and wear of the
wheel
every 10 opera-
ting hours
Check rim for damage
before and after
each ride
Clean with soft cloth and a suitable cleaner.
Attention: Do not use high pressure cleaners
or aggressive cleaning agents!
after each ride
Check that the wheels are secured correctly
and Check air pressure
before each ride
DISPOSAL AND ENVIRONMENTAL PROTECTION
The statutory regulations shall apply. Whenever possible, avoid
creating waste. Waste, especially carbon, lubricants, cleaners and
any other fluids must be disposed in an environmentally compatible
manner.
CONTACT
Black East GmbH
Beast Components
Hermann-Mende-Str. 5-7
01099 Dresden, Germany
+49 351 501 937 00
[email protected]
www.beast-components.de
V2021.01
Page 4
