21
Important Note (Reset Code)
In order to avoid the interference from the other wireless fish finder or the
receiver (main unit) doesn
’
t receive transmitter (transducer) signal, you can
reset the code between the receiver and transmitter yourself according to
steps below:
1.
Receiver: please make sure the receiver must be powered off, press the
Zoom key
first, then press the power key
at the same time,
and then the display becomes black right away (Black mesh in the middle
area of the display), after this you can continue doing the following steps.
2.
Transmitter: then check
the transmitter, you will
see a green button on the
transmitter
(see
the
picture) keep pressing the
green
button,
then
connect the power supply
to the transmitter. After
this, the receiver will be
powered off automatically.
In this condition, you can
release your hand from
the green button and
disconnect power supply from the transmitter. The product can be used
normally when you restart the machine after doing these steps above. If
the display of the receiver still stays black (Black mesh in the middle area
of the display), it means the reset of the code failed, then you need to
redo it once again according to the steps above. The channel number
will increase one by one after you succeeded to reset code each time.
Содержание BC201
Страница 1: ...BC201 User manual ...
