Beamz Panther 25 Led Spot, Инструкция по эксплуатации

Страница: 5 / 48

5
DISPLAY
The control board offer several features: you can simple set the starting address,
run the pre-programmed program or make a reset. The main menu is accessed
by pressing the
Mode/Esc
-button, browse through the submenu by pressing
Up
or
Down
.
Press the
Enter
-button in order to select the desired menu.
You can change the selection by pressing
Up
or
Down
. Confirm every selection
by pressing the
Enter
-button.
You can leave every mode by pressing the
Mode/Esc
-button. The functions
provided are described in the following schedule.
DMX-512 CONNECTION
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the
first unit in a DMX chain. Always connect the output of one unit with the input of the next unit until all units are connected.
5-pin XLR DMX Connectors.
Some manufactures use 5-pin DMX-512 data cables for DATA transmission in place of 3-pin. 5-pin DMX fixtures may be
implemented in a 3-pin DMX line. When inserting standard 5-pin data cables in to a 3-pin line a cable adaptor must be used.
The chart below details a proper cable conversion.
3-Pin XLR to 5-Pin XLR Conversion
Conductor 3-Pin XLR Female (Out) 5-Pin XLR Male (In)
Ground/Shield Pin 1 Pin 1
Data Compliment (- signal) Pin 2 Pin 2
Data True (+ signal) Pin 3 Pin 3
Not Used Pin 4 – Do Not Use
Not Used Pin 5 – Do Not Use
At the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-) and signal
(+) into a 3-pin XLR connector and plug this into the DMX output of the last fixture in the chain.
Selecting the DMX starting address and DMX mode.
Press the ENTER button until “DMX”, “SET” appears on the display. Now use the Up and Down buttons to select the “DMX”
menu item and confirm by pressing ENTER. “ADDR” now appears on the display and by pressing ENTER once more, you can
select the DMX start address as desired using the UP and Down buttons (A001 – A5002). After confirming with ENTER, “SAVE”
is briefly displayed on the display. To set the DMX operating mode, select the menu item “DMX”, press ENTER and then use
the UP and DOWN buttons to select the menu item “CHS”. Press ENTER and use the UP and DOWN buttons to select the
desired DMX mode (5Ch, 9Ch, 11Ch). After confirming with ENTER, “SAVE” is briefly displayed on the display. The
synchronous control of multiple spotlights (same model) through a DMX control unit (e.g. DMX console) can be achieved by
assigning the spotlights to an identical DMX start address and DMX mode and connecting them using DMX cables.
ENTER ENTER ENTER
MODE MODE MODE
UP UP
DOWN
DOWN
ENTER
MODE
UP
DOWN
UP
DOWN