AUTO Defaults
: Mostly automatic mode, for non-professional users, detailed explanation as
followings:
Slave Mode -->Slave 1
Black Out -->No
Sound State -->On
Pan Inverse -->No
Tilt Inverse -->No
Back Light -->On
(Notice: Other settings are NOT changed while choosing Defaults Setting!)
Press the
ENTER
and the corresponding functions will set to defaults setting, to go back to the
functions without any change press the
MENU
button again. Hold and press the
MENU
button about
one second or wait for one minute to exit the menu mode
Reset
Press the
MENU
button up to when the
Reset
is blinking on the display. Pressing
ENTER
button and
all channels of the unit will return to their standard position.
3.3
Home Position Adjust
In the main functions, hold
ENTER
button for at least 3 seconds into offset mode, use
DOWN
and
UP
button up to choose
Pan Offset
or
Tilt Offset
, Pressing
ENTER
button and the display will blink. Use
DOWN
and
UP
button to adjust the home position of the Pan, Tilt, Once the opposition has been
selected, press the
ENTER
button to setup, to go back to the functions without any change press the
MENU
button again. Hold and press the
MENU
button about one second or wait for one minute to exit
the menu mode.
4.
How to Control the Unit
You can operate the unit in two ways:
1. Master/Slave built-in preprogram function
2. Universal
DMX
controller
No need to turn the unit off when you change the DMX address, as new DMX address setting will be
effect at once. Every time you turn the unit on, it will show
“M108RGBW”
on the display and move all
the motors to their
“HOME”
position and you may hear some noises for about 20 seconds. After that
the unit will be ready to receive DMX signal or run the built in programs.
4.1
Master/Slave Buit-in pre-programmed Function
By lining the units in master/slave connection, the first unit will control the other units to give an
automatic, sound activated, synchronized light show. This function is good when you want an instant
show. You have to set the first unit in master mode
Show Mode
and select
Show 1
or
Show 2
or
Show 3
or
Show 4
mode. Its DMX input jack will have nothing plugged into it, and its master LED will
be constantly on and sound LED will flash to the music. The other units will have to set in
Slave mode
and select
Slave 1
(normal) or
Slave 2
(2 light show)mode, Their DMX cables plugged into the DMX
input jacks(daisy chain) and the slave led lights will constantly on.
2-light show
In
Slave mode
,
Slave 1
means the unit works normally and
Slave 2
means 2-light show. In order to
create a great light show, you can set
Slave 2
on the second unit to get contrast movement to each
other, even if you have two units only.
