Beamz illusion 2, Инструкция по эксплуатации

Страница: 5 / 40

5
DISPLAY
The control board offer several features: you can simple set the starting address,
run the pre-programmed program or make a reset. The main menu is accessed
by pressing the
Mode -button, browse through the submenu by pressing Up or
Down .
Press the
Enter -button in order to select the desired menu.
You can change the selection by pressing
Up or Down . Confirm every selection
by pressing the Enter -button.
You can leave every mode by pressing the
Mode -button. The functions provided
are described later in this manual.
DMX-512 CONNECTION
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the
first unit in a DMX chain. Always connect the output of one unit with the input of the next unit until all units are connected.
If you use a controller with 5 pin DMX connection you will need to use a 5-pin to 3-pin adapter.
At the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-) and signal (+)
into a 3-pin XLR connector and plug this into the DMX output of the last fixture in the chain.
MENU FUNCTION SETTING
1
）
DMX address setting
1. Press <MENU> to enter EDIT interface.
2. Press <UP/DOWN> to choose, then press <ENTER> to enter (DMX address).
3. Press <Up/Down> to choose address 001~XXX.
4. Press <ENTER> to confirm, or press "MENU" to exit.
2
）
Channel mode Setting
1. Press <MENU> to enter EDIT interface.
2. Press <UP/DOWN> to choose, then press ENTER to enter (Channel mode).
3. Press
UP/DOWN to choose each channel “12CH” or “23CH”.
4. Press ENTER to confirm, or press "MENU" to exit.
3) Scene Setting
1. Press <MENU> to enter EDIT interface
2. Press< UP/DOWN> to choose, then press ENTER to enter (Scene Choose)
3. Press< UP/DOWN> to
choose light’s three shows:Sh1,Sh2,Sh3 (can choose any show mode which is activated by
sound).
4. Press <Enter> to confirm, or press "MENU" to exit.
4
）
Master-slave setting
1. Press <MENU> to enter EDIT interface.
2. Press <UP/DOWN> to choose, then press ENTER to enter (Master Mode).
3. Press <UP/DOWN> to choose Mast/SL1.
4. Press <Enter> to confirm, or press "MENU" to exit.
5
）
DMX Lost Setting
1. Press< MENU> to enter EDIT interface.
2. Press <UP/DOWN >to choose, then press ENTER to enter (Lost DMX mode).
3. press< UP/DOWN> can
choose light’s 4 scenes: hold, sound, auto and black
(can choose any scene mode to operate).
4. Press <Enter> to confirm, or press "MENU" to exit.