2. Installation
Remove all packing materials from the
DMX1360 Controller
. Check that all foam and plastic padding is
removed. Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing. Damages
caused by non-observance are not subject to warranty.
3. Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
3.1 Set up moving light effects
DMX channels 1 to 113 are reserved for the moving lights. Channels 129 to 136 are reserved for the
static DMX channels, at the parcan section (
B
) of the DMX1360 Controller.
DMX Fixture start addresses are:
FIXTURE1
DMX START ADDRESS: 01
FIXTURE2
DMX START ADDRESS: 17
FIXTURE3
DMX START ADDRESS: 33
FIXTURE4
DMX START ADDRESS: 49
FIXTURE5
DMX START ADDRESS: 65
FIXTURE6
DMX START ADDRESS: 81
FIXTURE7
DMX START ADDRESS: 97
FIXTURE8
DMX START ADDRESS: 113
Before you start programming, the console first has to be patched.
Hold down the SETUP button (
11
) for 5 seconds, the green LED will illuminate. With the UP/DOWN
buttons (
17
&
18
) you have to choose “2. ASSIGN CH” and then press the RECORD button (
15
).
The LCD now shows:
CHANNEL01>OUT01
OK ESC SEL ADJ
This means Controller Channel 1 now sends a signal to DMX address 1. You can change the DMX
address by pressing the DOWN button (
18
), until you see the address you want. By pressing the UP
button (
17
), you can change the Channel of your DMX1360 Controller. To save a channel patch, you first
have to select a fixture (
3
) and then press RECORD (
15
). Make sure all channels are only used once.
After the display shows:
CHANNEL16>OUT16
OK ESC SEL ADJ