ENGLISH – Motorized screen user manual
Specifications are subject to change without notice. E&OE
Doc: XL Series – HOME CINEMA MODULES Installation Manual rev3 | 21.05. 2013
Please verify that you are working with the latest revision of this document before specifying your screen.
Page 9
VERSION WITHOUT CASE
1)
Important: make absolutely sure that the motor and the end cap of the pivot are correctly inserted into the roller, as transportation can sometimes cause them to become dislodged and to protrude
slightly from their original position.
2)
Check the distance of the two side brackets mounted on the screen. Then dismantle the bracket on the side of the motor by loosening the two lateral screws, and the bracket on the pivot side after
removing the metal cotter pin to release the pivot.
3)
Then mount the two brackets on the wall or ceiling at exactly the same distance previously checked, using suitable toggle bolts for the surface on which the screen is to be installed.
4)
Mount the screen on the brackets by inserting the screws on the motor and pivot sides, and blocking the pivot with the metal cotter pin provided.
08 COUNTERWEIGHT TENSIONING ADJUSTAMENT
09 MOTOR TYPE IDENTIFICATION –CHARACTERISTICS – ELECTRICAL CONNECTION
The type of motor installed on the product is identified by a label applied on each product showing the CE logo. When unwrapping the product please check the model type indicated on the label in order to
perform the installation and cable connections correctly. Should the power of the motor be different from that of the supply network of the installation place, please contact an electrician to have a current and
Hz transformer installed.
ELECTRICAL CONNECTION:
electric cabling must be conformant with applicable IEC standards. IEC norm EN 60335-1 requires that supply network be fitted with an omnipolar selector
switch with contact opening distance of at least 3 mm. For the screen’s control use only the selector switch provided by manufacturer, or equivalent model,
and follow the instructions of the connection diagram shown on left (if the motor is mounted on the left, the colours of the wires must be inverted, i.e.
descending = brown, ascending = black). The selector switch must be mounted within sight distance of the product, at a 1.5 - 1.8 m height from the floor. To
connect the wires to the supplied switch, remove the plastic front plates to access the lock/unlock buttons
WARNING:
Correctly performed, state-of-the-art, norm-compliant electrical connections are important to prevent accidents and to ensure the screen’s optimal and
unaltered performance over time. Prior to carrying out any operation on electrical parts ensure that power supply is disconnected. In screens fitted with cases
the motor is positioned on the right-hand side of the screen as seen from the front (upon request it can be located on the left). Never connect two or more
motors to the same selector switch without a control unit or two switches to the same motor.
230V 50Hz
Motor characteristics:
Frequency: ~Hz50
Power: 170W
Torque: 15Nm
Speed: 17Rpm
Max no. of cycles: 2
Cable length: 3mt
Mechanical strength:
EN14202 conformant
Operating T°:
from –20 to +55 °C
Connection for each motor:
n
Brown (Up)
o
Black (Down)
p
Blue (Common)
f
Yellow Green (Ground 230V)