Beam Solaire Power Team, Руководство пользователя

Страница: 5 / 16

3. Insert hose end into the powerbrush wand on the assembled powerbrush until is locks in place. (figure 5a)
4. Insert the hose into the wall vacuum valve (faceplate), and plug the cord into the electrical outlet. (figure 5b)
5. You may secure the powerbrush by placing your foot on top of the hood. Lower the wand from the upright position.
6. Switch the powerbrush to the ON position. (“II”)
7. The wand can be telescoped by pushing the button closest to the powerbrush and pulling up.
8. To turn off the powerbrush, slide the switch to the OFF position. (“O”) Disconnect the handle from the wand by push-
ing the button on the wand that is closest to the handle, and pulling the handle out of the wand socket.
9. Release the wand from the powerhead by depressing the foot pedal and pulling the wand out of the powerbrush socket.
Helpful Hint: To prevent possible damage to the Powerbrush, do not pick up hard or sharp objects. Articles of clothing,
towels, loose carpet edges, etc., should also be avoided. If an article does become entangled in the brush roller, switch off the
Powerbrush. Disconnect the hose cord from electrical outlet and the hose from the faceplate and then remove the object
carefully without using excessive force.
WARNING: Always switch off the Powerbrush and disconnect plug from wall electri-
cal outlet and disconnect hose before servicing the Powerbrush.
General Cleaning
The Powerbrush can be wiped with a cloth dampened with warm water and a mild detergent.
1.
Do not use abrasive substances.
2. Do not use any solvents.
3. Do not immerse in water or allow water to enter the Powerbrush.
Brush Roller Cleaning
For top cleaning performance, it is recommended that the brush roller and the
brush roller compartment be cleaned on an occasional basis.
WARNING: Always switch off the Powerhead and
disconnect plug from wall outlet and disconnect hose
before servicing the Powerbrush.
1. Turn the Powerbrush upside down.
2. Press the 3 snap release clips (as shown in Figure 6) and remove brush cover.
3. The brush roller is now exposed for removal of fibers, hair, etc. from the bris-
tles and around the brush roller.
4. To remove fibers or hair entangled around the brush roller, cut parallel to brush
roller.
5. You may further clean the brush compartment with your central vacuum sys-
tem.
6. Replace the brush cover by inserting the tabs on the front of the cover into the
appropriate slots in the Powerbrush base (as shown in Figure 7) and press down
on the three clips until they snap-lock into place.
Figure 5a
Figure 5b
Figure 6
Figure 7
5