Beam SatDOCK RST980, Инструкция по установке и эксплуатации

Страница: 40 / 43

RST980 INSTALLATION & USER MANUAL
40
A
Ensure the signal strength is at 5 bars on the handheld terminal
Check your location and for interference
Keep in mind that on hands-free calls there may be background
interference from environmental noise
Remember all satellite network have a slight delay in the call
Q Battery not charging on the cradle
A
Check to make sure that the connector cable is connecting properly
Ensure the 12V DC cable has not become loose or disconnected
Ensure the 12V DC cable was installed correctly
Q I get a message asking me to rotate the antenna whilst the handset is
in the SatDOCK cradle.
A
This can occur in earlier firmware versions of the 9505A handset.
To enable / disable this message, using the keypad on your 9505A
handset, type in the following code: *#92#
Q Phone powers off once the ignition is switched off or the key is
removed.
A This is normal operation; however connecting the ACC cable to a constant
power source on the vehicle will rectify this, if such an operation scenario is
required.
Q There is no Audio from the Speaker
A Check that the speaker connector is installed directly to the HFI kit.
Check that the interface cable from the HFI to the SatDOCK is connected
Check the signal strength on the intelligent handset
Q Party B cannot hear your voice
A Check that the microphone connector is installed directly to the HFI kit.
Check that the interface cable from the HFI to the SatDOCK is connected
Check that the SatDOCK is not in mute or privacy mode.
Check the signal strength on the handset
Q You can’t make calls.