88
OPERATING INSTRUCTIONS
CARE AND MAINTENANCE
• Store the Fire Pit in a cool dry place away from direct sunlight.
• The propane tank must be disconnected and removed from the Fire Pit before the Fire Pit can be stored indoors.
• Use manufacturer-approved or -supplied replacement parts and accessories only. Use of unauthorized replacement parts may void the warranty.
• Keep Fire Pit free and clear from combustible materials.
• Visually inspect burner ring for blockages (spider webs, dirt, etc.). Keep Fire Pit free and clear from debris.
To Extinguish
See f igure 11
1. Push and turn control knob clockwise to "OFF" position.
2. Turn cylinder valve on gas tank to close gas supply if not in use for a long time.
WARNING! Do not place lid or nylon f ire pit cover on top of Fire Pit for at least 4 hours
after use and until Fire Pit has cooled.
WARRANTY
The manufacturer's warranty will be voided by, and manufacturer disclaims any responsibility for,
the following actions:
• Use of any component part not manufactured or approved by manufacturer.
• Use and installation other than as instructed in this manual.
OPERATING INSTRUCTIONS
CARE AND MAINTENANCE
WARRANTY
Before each use, open the door to inspect hose. Replace hose if there are any signs of cutting, wear or abrasion.
WARNING!
and cause injury to the face or eyes.
Caution: Only use pressure regulator and hose assembly supplied with Fire Pit. Replacement
pressure regulator and hose assemblies must be speci
fie
d or supplied by manufacturer.
To Light
1. Turn cylinder valve on top of propane tank counterclockwise to open gas supply.
2. Close door on body of Fire Pit.
3. To ignite burner ring:
See f igure 10
a) press and hold electric igniter button (a), and
b) at the same time, push in and turn control knob (b) counterclockwise, to LOW position.
c) Keep the control knob (b) pushed in to light the burner ring.
WARNING! If ignition does NOT immediately occur
• release electric igniter button (a) and turn control knob to OFF (clockwise).
• WAIT 5 MINUTES to clear out the gas!
• repeat lighting instrutions in Step 3, above
4. After ignition, release electric igniter button (a).
Continue to push and hold the control knob for 45 seconds.
Note: Flame should be yellow/blue color.
i
i
i
i
i
a
b
10
a
b
11
