3
VIO-ST
4
+
+
A
B
Launch an
ASSISTED SETUP
to verify wiring, position of the
curtains and correct functioning of the sensor.
SETTINGS
(by DIP-switch)
QUICK SETUP
ASSISTED SETUP
SETUP
OPEN+CLOSE
RED-GREEN
OFF
RED-GREEN
OFF
Step outside of the detection field before launching a setup.
LONG (> 3s)
LONG
SHORT
standard
critical
environment
standard
extreme
1
1
Enhanced IR-immunity which excludes EN 16005-conformity of the door system.
LONG (> 3s)
critical environment
: enhanced immunity for critical environments (rain, snow, lamps...). Only 1 IR-curtain activated.
standard
: standard environments (factory setting)
NC
NO
The yellow and white wires have to be connected to launch an
assisted setup.
After changing a DIP-switch, the orange LED flashes.
A LONG push on the push button confirms the setting.
Always launch a setup after changes of the DIP-settings.
- Test the good functioning of the installation before leaving the premises.
- The manufacturer of the door system is responsible for carrying out a risk assessment and installing the sensor and the door system
in compliance with applicable national and international regulations and standards on door safety and if applicable, the machinery
directive 2006/42/EC.
- The device cannot be used for purposes other than its intended use. All other uses cannot be guaranteed by the manufacturer
of the sensor.
- The manufacturer of the sensor cannot be held responsible for incorrect installations or inappropriate adjustments of the sensor.
- Only trained and qualified personnel may install and setup the sensor.
- The warranty is void if unauthorized repairs are made or attempted by unauthorized personnel.
- Avoid touching any electronic and optical components, avoid vibrations, do not cover the sensor and avoid proximity to
neon lamps or moving objects.
- It is recommended to clean the optical parts at least once a year or more often if required due to environmental conditions.
SAFETY INSTRUCTIONS
PRESETTINGS
ENVIRONMENT
R2 CONFIGURATION
FREQUENCY
ORANGE
OFF
