75.5911.02 20180226
Page 2 of 9
q
The sensor must be firmly
fastened to prevent vibration.
q
Sensor must be in a location that does
not interfere with door hardware (finger
guards, lock rods, etc.).
q
The sensor must not have any
unwanted objects likely to
move or vibrate in its path.
1.
Remove the screw that secures the endcap to the SuperScan-T extrusion (image below, left).
2.
Remove the plastic lens by pulling the lens out from the top of the extrusion (image above, right). Do not use a screwdriver to pry the lens, as
cracking may occur.
CAUTION!
REMOVE THE MASTER AND ALL SLAVE CIRCUIT BOARDS FROM THE ALUMINUM EXTRUSION
BEFORE PERFORMING ANY DRILLING.
WHEN COMPLETE, ENSURE THAT ALL METAL SHAVINGS ARE CLEANED FROM THE EXTRUSION
BEFORE RE-INSERTING THE CIRCUIT BOARDS.
3.
The image below (left) shows the angle adjustment clip in its proper position within the extrusion (PCBs removed and clip shown at end of
extrusion for clarity only). To remove the clip, simply pull the tab out away and downward from the extrusion, then rotate the module out from
extrusion (image below, right). To re-install, simply reverse the procedure. The PCB must first be installed into the adjustment clip, then installed
into the aluminum extrusion.
IMPORTANT NOTE: The end of the extrusion that is towards the pivot end of a center-hung door, should be in far enough from the edge of
the door (image below, left) to prevent the endcap of the SuperScan-T from rubbing against the finger guard during door movement. Pay
particular attention on the safety side of the door. Hinge-hung doors will not require as much clearance between the end of the SuperScan-T
and hinge-side jamb (image below, right). At the leading edge of the door, the edge of the SuperScan-T, including the endcap, should be as
close as possible to the leading edge of the door, without creating mechanical interference with the door jamb or with an adjacent door (pairs).
4.
Hold the SuperScan-T extrusion up to the top of the door. Ensure that the extrusion is oriented correctly.
1
MECHANICAL
INSTALLATION
PREPARING AND
MOUNTING THE
SENSOR
INSTALLATION
TIPS
Back Side
Top Side
