Page 6 of 12
75.5792.05 LZR-S600 20180814
1
2
a
d
b
e
f
g
h
c
Page 6 of 12
75.5792.05 LZR-S600 20180814
MOUNTING
Use the mounting
template to position the
sensor correctly.
The gray area indicates
the detection range.
Pass the cable ±4 inches
through the cable
opening.
If drilling an opening is
not possible, use the cable
conduits on the back side
of the bracket.
Drill 4 holes as indicated
on the mounting
template.
Drill a hole (1/2 inch min.)
for the cable if possible.
Position the bracket and
secure using the 4 screws
to avoid vibrations.
WIRING
Rotate the sensor until
the two triangles are face
to face.
Position the housing on
the bracket.
Close and secure the
protection cover.
NOTE:
FACTORY WARRANTY
VOIDED IF PROTECTION
COVER IS NOT USED!
Open the protection
cover, plug the connector,
and position the cable in
the slit.
Use the visual aid below to ensure correct wiring to the door control.
CONNECTOR
(side view)
BLACK
CONNECTOR
RED
BLUE
WHITE
BLUE/WHITE
GREEN
ORANGE
WHITE/BLACK
ORANGE/BLACK
GREEN/WHITE
WIRE COLORS FUNCTION
Power supply (12 – 35 VDC)
Red (+)
Black (-)
White
Green
White/Black
Green/White
Blue (+)
Blue/White (-)
Orange
Orange/Black
Relay 1: Opening Field
Relay 2: Safety Field
Test
Learn
No test function:
connect blue and blue/white wires to power supply
(no polarity)
No Learn via input:
connect orange and orange/black wires to ground/
common
To
launch a Learn
, apply power for the
length of time in which the Learn is to be
performed (minimum of 1 millisecond).
