6/8
During an adjustment session all parameters may be reset to their factory values in the following way :
PARAMETERS
OPERATIONS
FACTORY
VALUES
Press the
SETUP
key (19), then press the
NUMBER
key
9.
All the parameters (except the access code) are reset to the factory values.
FACTORY VALUES :
Factory Values Table
Parameter
Values
Factory setting
Sensitivity
0 - 9
7
Hold time
0 - 9
0
X-MTF Sensitivity
0 - 9
0
Detection mode
1 - 5
2
Immunity
1 - 3
2
Mounting height
1 - 2
1
Output configuration
1 - 2
1
Door control
1 - 3
1
If you do not have a remote control, you can only adjust the sensitivity parameter, by means of the push b and - .
+
: press to increase the sensitivity by one unit
-
: press to decrease the sensitivity by one unit
The factory default values (except the factory value of the access code) may be restored by pressing the two push buttons together for
at least two seconds.
The LED flashes for a few seconds after the power-on, and flashes during the
configuration with the remote control.
The LED lights up when the sensor detects motion.
SYMPTOM
PROBABLE CAUSE
CORRECTIVE ACTION
The door will not open and no red LED
lights up.
The sensor power is off.
The door control is set to level 3.
Check the wiring and the power supply.
Set door control to automatic mode (level 1).
The sensor "sees" the door
moving.
Increase the tilt angle and/or reduce the sensitivity
and/or increase the immunity.
The door opens and closes constantly.
When closing the door creates
vibrations picked up by the sensor.
Ensure that the sensor is correctly fixed.
Switch to unidirectional mode.
Increase the immunity.
Reduce the sensitivity.
The door will not close.
Red LED OFF
On-Off switch at door control in
wrong position or is faulty
Improper output configuration on
the sensor.
Check to insure On-Off switch for door is in the ON or
AUTOMATIC position.
Check the output configuration setting on each
sensor connected to the door operator.
The X-MTF mode is not functioning
correctly.
Cut and restore power supply.
Step out of the detection field and wait for about ten
seconds. The sensor has to take a new reference.
The sensor stays in detection
permanently when X-MFT is activated.
The sensor detects motion in the
detection zone.
Note: When X-MTF mode is
activated the detection zone is
slightly bigger.
Check whether there are moving objects in the
detection zone or decrease the X-MTF sensitivity and
increase the hold time.
SENSITIVITY
CONFIGURATION
WITH PUSH
BUTTONS
LED SIGNAL
TROUBLE-
SHOOTING
