2/8
From behind, before installation
From the front, after installation
•
Paste the template.
•
Drill as instructed.
•
Insert screws, but do not screw them
fully home.
•
Run the cable through the hole.
•
Cut one of the cable openings for the
wire.
Position the sensor and tighten the two screws. Leave wires long
enough to reach the terminal block.
12-24V
AC/DC
COM
NO
NC
This device may be fixed on the ceiling, as long as the
spherical part of the sensor is facing in the direction
opposite the door, and as long as an angular position of
around 70° is chosen for the antenna.
For the mounting on the
upper part of the door
operator profile, use the
EBA
support.
For a mounting into the ceiling, use the
ECA
embedding
support.
For a better water tightness,
use the
ERA
protection cap.
OPENING THE
SENSOR
PREPARATION
FOR MOUNTING
THE SENSOR
WIRING AND
MOUNTING THE
SENSOR
OTHER
MOUNTING
OPTIONS
