22
23
START THE GENERATOR RECOIL START
CONNECT TO LOAD
Stopping the Generator
DISCONNECT LOAD
TURN OFF THE ENGINE SWITCH
OPEN THE CHOKE VALVE
Start via the pull wire: Pull the wire gently to connect the disc to the
starting bowl inside the unit. Pull the wire out in an instant action and
the generator unit will be started after doing this twice. If it is not started
please conduct the above operation with the choke valve.
Access electric equipment and turn the circuit breaker to ON Please note
that when several loads are used at the same time do not access the
next one unless the former one is running normally The total power of the
loads should not exceed the rated power of the unit.
Disconnect the electric equipment from the control panel of the
generator.
After 30 seconds of no load running turn off the engine switch and the
generator unit will be shut down immediately.
After starting, let the unit run without load for 5 seconds and then turn on
the choke valve switch.
WARNING
It may be causing the dangers of injury by the sudden change of rota-
tion direction of the engine during operating the recoil starter.
OPERATION
OPERATION
