Seite 13 von 17
Assembly of the fanhead
1. Remove the spinner lock nut and guard lock nut from the motor shaft.
2. Fit the rear guard, by the positioning on the location shaft pins. Secure the guard to the
motor body with the guard lock nut.
3. Push the fan blade onto the motor shaft by matching the slots on the base of the blade with
the shaft pin. Secure the blade with the spinner lock nut. The spinner lock nut must be
tightened by turning it in a counter-clockwise direction. Check that the fan blade rotates
freely by turning with your hand.
4. Open the securing clip at the bottom of the front guard and loosen the clip screw. Position
the top clip on the uppermost part of the rear guard. Push the top clip down and press the
rim of the front guard onto the rear guard. Close the bottom clip and tighten the screw.
START UP
1. Place the device on a flat and dry surface (no use in wet rooms).
2. Plug the plug into a standard 220 ~ 240V outlet.
3. The functions of the fan can be adjusted both by means of the remote control and
directly on the device with the buttons of the control panel.
Commissioning the remote control
Please note the following instructions:
1. Push the cover off the back of the remote
control to remove it.
2. Now insert the two supplied 1.5 V batteries
of type R03 "AAA"
(To insert the batteries
correctly, observe the instructions on the
inside of the battery compartment).
3.
Put the cover back onto the remote control.
1
2
3
