BE Ag & Industrial CAR-TM Series, Руководство по эксплуатации и запасным частям

Страница: 7 / 14

CAR-TMXXXX USER MANUAL
7
IN THE VARIOUS WORKING POSITIONS
the PTO shaft transmission hoses shall telescopically insert of at least 150mm as shown in the figure
below. Repeat the check when the tool is hitched to a different tractor.
ANY MODIFICATIONS
to the PTO shaft are strictly prohibited. It is strictly prohibited to cut the PTO shaft in order to adapt its
lenght.
i
THE PTO SHAFT GUARDS
Shall be still and in good conditions while the PTO shaft rotates, therefore, only the pre-stablished chains
shall be used. For your safety, when the PTO shaft guards are worn, they shall promptly be replaced.
When the machine is not in service, to prevent the PTO shaft from resting on the ground, use the extra
chain supplied in our kit rather than the two small rotation-proofing chains supplied with the PTO shaft.
Never leave the PTO shaft on the ground. When the PTO shaft is being clutched in, make sure it is
correctly locked in position.
COMMISSIONING.
See picture nr. 1
1. Position U-Bolt “6” and tighten screws “7”, washers “8” and nuts “9”. For models with displaceable hitch,
choose the position most suitable for your work.
2. Place guards “2” (Which shall never be removed for safety reasons) and for packaging cannot be
mounted before shipment. Tighten them with screws “3” and washers “4”. Place the plastic PTO guard “5”
by interposing the preset reinforcement disc under the screws (Guards “2” are necessary and demanded
for the CE European market only).
3. Fill the gearbox with oil as shown in the table on page 8 of the manual. Then grease points 1 with EP2
grease every 8 to 10 hours’ work.
Adjustment of belt tension and cutting height
See picture nr. 2
1. A correct stretch of the belts will let your machines run smoothly for their best performance. Every 10
hours’ operation check the belt stretch carefully. Proceed as follows after the tractor engine off and
waiting until all moving parts have stopped:
• Remove the guard
• Tighten nut “10” to stretch the belts, loosen the belts
• Mount the guard back in place
2. Proceed as follows after switching the tractor engine off and waiting until all moving parts have stopped:
• Lift and rest the machine on solid stands
• Loosen and remove screws “11” and adjust the height by lowering shoe “12” and roller “13” to the same
height.
• Repeat the operation on the opposite shoe. Remember that to be able to use the machine correctly, shoe
“12” and roller “13” shall work at the same height. For packaging reasons, the roller can be positioned
higher