BE Ag & Industrial 57GUNMOD, Руководство по эксплуатации и запасным частям

Страница: 4 / 11

OPERATION INSTRUCTIONS
57GUNMOD
IMPORTANT -
If you want to clear the total filling data, please operate as below:
a) Press and hold the Reset button until you see Picture C, and then click the Reset button, until you see
Picture D.
b) Then click the Reset button, it will show Picture E, press the left button (Total) and then long hold down
the Reset key, the screen will show Picture F and Picture G, which means the cumulative is clear,
complete and save.
5. If the instrument does not operate for 10 seconds, it will automatically enter the sleep state
(power saving mode), when any button is pressed, automatically enter the running state,
now you can start to work.
6. When the battery is getting low, the flow meter will show L1-L0 flashing, this means the you need to
replace the battery.
7. After 30 seconds of oil filling the device will save the data automatically.
OPERATING INSTRUCTIONS
1. According to the requirements, before operation, please prepare an appropriate standard of measuring
capacity (such as 5L).
2. The current value should be cleared, as shown in Picture 1, the oil gas handle filled on certain amounts of oil
into the cup, (such as 3L), then the screen will appear on the corresponding value of filled (such as 3.26)
as shown in Picture 2.
a) Press two buttons about 5-10 seconds at the same time to enter Set State (Picture 3).
b) Press Reset to select unit (LIT, GAL, QTS, etc. as in Picture 2.