Operation of the Unit
1. In standard operation, the PIR will
now sense body heat when passing
through the detection zone. Each time
the PIR is triggered the red LED will
light and reset the timer back to the start
of the timing period. The unit will then
wait 20 seconds approximately
before allowing the PIR unit to sense
and re-trigger the timing period again.
2. If no one is present in the room or the
detection zone is not passed through,
during its set time period the timer
will time out, turning off the lights or
appliance and the blue indicator/locator
ring will light up.
3. The PIR unit will only trigger the lights or
appliance if the ambient light level is
below that set on the lux level adjustment.
4. When the ambient light level is light
enough so the lights would not normally
come on with PIR use, the override switch
can be used turn on the lights for the set
period time. This can be used in times
where addional light is required in a room.
To operate press the PIR lens, the red
indicator LED will light to show it has
been pressed and the timing will begin,
in the last minute of timing the red
LED will fl ash.
5. When the ambient light level is dark
enough that the PIR is in normal
operation, the override switch can be
used to disable the PIR and the lights
turned off indefi nitely or until the
override switch is pressed. This can be
done by pressing the PIR lens, the red LED
will fl ash rapidly to indicate the PIR has
been disabled and can be re-enabled
simply by pressing the lens again.
N.B. The PIR will require approximately
1 minute to initialise.
Brook House,
Dunmurry Industrial Estate,
Dunmurry,
Belfast BT17 9HU
T +44 (0)28 9061 6505
F +44 (0)28 9061 6518
E [email protected]
elkay.co.uk
BROOK DESIGN HARDWARE LTD
B
D
H
B
D
H
BROOK DESIGN
HARDWARE LTD
B
D
H
BROOK DESIGN
HARDWARE LTD
BDH
BROOK DESIGN
HARDWARE LTD
B
D
H
Picture 4
Elkay (Europe), 51C Milicka, Trzebnica, 55-100, Poland
Technical Helpline
For further help or assistance or information on this or other products in the range
please call the Elkay Technical team on +44 (0)28 9061 6505. Please call the
Technical helpline before returning any products to your stockist. These instructions
are available in other languages. Please refer to our website www.elkay.co.uk
Instrukcje są również dostępne w innych językach. Prosimy o zapoznanie się z naszą
stroną internetową www.elkay.co.uk lub www.elkaypolska.pl
Important Notice
All wiring should be carried out by a competent
person or a qualifi ed electrician and should be
fi tted to current IEE wiring regulations BS 7671.
The circuit should be isolated before carrying out
any work. Failure to adhere to the instructions
will invalidate the warranty.
