10
|
WARNINGS REGARDING BATTERIES
•
Do not mix alkaline, standard (carbon zinc) and rechargeable (nickel hydride) batteries.
•
Do not mix old and new batteries.
•
Non-rechargeable batteries should not be charged.
•
Rechargeable batteries should be charged under adult supervision only.
•
Exhausted batteries should be removed.
•
The supply terminals should not be short-circuited.
•
Do not put batteries next to or in a heat source (fire, electronic heating device, etc.).
•
Do not hit batteries against hard objects.
•
Do not submerge batteries in water.
•
Batteries should be inserted with the correct polarity.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
This product may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING: Any changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Responsible party (contact for FCC matters only):
Quality Control Dept.
15101 Red Hill Ave.
Tustin, CA 92780
FCC COMPLIANCE STATEMENT
